基于膠膜轉印的氣動微閥及微流控芯片
在PDMS薄膜上可控地制備了厚度約為1μm膠膜,隨后利用微米級的膠膜實現了PDMS薄膜與PMMA微流道層的膠粘鍵合,既避免了微流道的堵塞,又保證了微流道結構的精確性。設計并制備了由上層氣體通道、中間柔性薄膜和下層液體通道構成的氣動微閥,由上層氣體通道內輸入氣壓驅動PDMS薄膜向下層的液體通道變形以實現流體控制功能。
使用氧等離子清洗機PLUTO - F,對PMMA進行氧等離子體處理,功率為1 0 0W,處理時長為6 0s ,以增加其表面能,隨后使用勻膠機將雙組分低粘度環氧樹脂膠 EAE-30CL,
均勻地甩在無結構的PMMA 板上,設置轉速為5000r/min,時間為30s 。
接著將氧等離子體處理后的PDMS薄膜與PMMA貼合,并用滾輪去除氣泡,使膠膜轉印到PDMS薄膜上。
接下來將硫酸紙和PDMS薄膜貼合,使用滾筒去除二者之間的氣泡,再把硫酸紙和PDMS薄膜分離開,硫酸紙將吸附一定厚度的膠膜,從而使P DMS薄膜上的膠膜變薄。
接著,重復前一步的流程,直至PDMS薄膜上的膠膜厚度降低至約1μm。
最后,將帶有微米級厚度膠膜的PDMS薄膜與下層帶有液體通道的PMMA貼合,等待膠粘劑固化24h后完成第一步鍵合。
PLUTO-F等離子清洗機在PDMS微流控領域中起到了非常重要的作用,增加了粘合力,確保芯片的結構穩定性和密封性,為微流控技術的發展提供了更廣闊的空間和可能性。